Call now to get tree supporting including tree removing, tree removal, bush drop, shrub clearance, stump grind and a lot of others all over USA:


Call now

Call now +1 (855) 280-15-30






The OEM bushings with tapered ends are easier to remove.

The E36/E46 Trailing Arm Bushing Tool - RENTAL is a must for any DIY mechanic who doesn't like to waste time struggling with jobs that should be quick and easy. This trailing arm bushing tool is simple to use and is similar to theBMW version, but at an affordable rental price with the convenience of being delivered to your door. Install the correct bushing “press adaptor” that is required for the type of bushings that you are removing, into the small cup. Slide the puller tool threaded rod through the control arm bushing with the thin washer behind the rod bolt end and with smaller cup positioned as shown in the picture.

Mark forward trailing arm carrier bracket for later re-installation. Unbolt forward trailing arm carrier bracket from chassis and lower front of trailing arm to gain access to bushing. 3. Unbolt bracket from bushing and remove from trailing arm.

If needed push the small cup in the direction it needs to move to center itself over the bushing taper while hand tightening the nut.

Mark so that the new bushing can be inserted in the same orientation. 4. Install bushing tool on. Pressing your own control arm bushings can offer a savings in some cases. (The easy route is to buy them pre-installed from us, when available.) You'll need tools to both press out your old bushings from the control arm or bushing carrier as well as press in the new bushing.