Call now to get tree supporting including tree removing, tree removal, bush drop, shrub clearance, stump grind and a lot of others all over USA:


Call now

Call now +1 (855) 280-15-30






Model: Mercury Years: 4 required Model: Passenger Years: 4 required.

This browser is not supported. To get the best experience using treemulch.buzz site we recommend using a supported web browser(s): Chrome, Firefox. Product description. The OTC A Truck Front Leaf Spring, Pin and Bushing Service Set delivers 10 tons of hydraulic force to remove and install truck front spring eye bushing assemblies quickly and easily.

Services bushings with diameters from /4 inch through /8 inch and pin diameters from 7/8 inch through /8 inch/5(29). Shop at Marblehead Hardware at 70 Atlantic Ave, Marblehead, MA, for all your grill, hardware, home improvement, lawn and garden, and tool needs.

Feb 27, Then, one at a time, each frame bracket was heated up again with the MAPP torch, the new bushing was removed from the ice cup and dipped into chassis grease, then started by tapping lightly into place with a hammer and finally pressed home with the 3-in-1 tool and impact wrench.

I didn't even burn myself! The spring eyes were done the same way. Truck Front Leaf Spring and Bushing Service Set. Delivers 10 tons of hydraulic force to remove and install truck front spring eye bushing assemblies quickly and easily. Services bushings with diameters from /4" through /8". Handles all popular OE and aftermarket components. Service bushing assemblies, in many cases, without. treemulch.buzzase comment, like, subscribe and share!You can also fine me on Twitter & Instagram - @GettinJunkDoneUse this link to shop on.

Oct 15, Keep the jack under the rear end. Do one end of a single spring at a time, removing the bolt securing the spring into the front pocket and/or the leaf spring and frame bolts on the rear shackle as required.

This keeps the rear end properly located. 3. Remove the bolt and lower the jack completely to perform the repair described below. Both the front and rear eye of the front and rear spring uses the same bushings.

In one end bushing is a steel encased rubber bushing. There is a steel inner sleeve, then rubber, then a steel outer shell. This outer shell is only about 1/16″ thick. The best way to remove these bushings is.